LG LE4016D-NH Manual do Utilizador descarregar pdf (Página 16)

Installation

Connecting Network

You can control and monitor the system via network. With

the remote control (monitoring), you can change the system

conguration or monitors the image via network. After the

installation, check the network settings for the remote control and

monitoring work.

Network connection

Router

Broadband

Service

LAN connection

Connect the LAN port to an available 10/100/1000 base-T port with

a straight ethernet cable (not supplied). The NET indicator on the

front panel will be lit.

IP Camera connection

Connect the IP camera. After the installation, check the IP camera

settings on the setup menu.

Automatic network conﬁguration

The DVR can automatically obtain and congure the network

interface via DHCP.

Manually conﬁgure network

The DVR may be manually congured by assigning an IP address,

subnet mask, gateway and DNS.

Connecting RS-485 device

This DVR has two data terminals. Use this port to connect PTZ

cameras, DVRs or keypads (optional).

RS-485 Terminal Description

D - (DATA -) Data Transmission/Reception

D + (DATA +) Data Transmission/Reception

GND Shield

Connecting the PTZ device

Connecting the PTZ serial communication lines to the

RS-485 terminal.

PTZ device connection

5~7 mm

PTZ units

(RS-485 type)

PTZ units

(RS-485 type)

NOTE

• When connecting lines, connect the “D -” of the DVR to “RX -”

of the PTZ unit and “D +” of the DVR to “RX +” of the PTZ unit

correctly.

• Recommended initial data are 9600 Baud Rate, 8 Data bits,

1 Stop bit and No parity.

• When connecting PTZ cameras to DVRs it is necessary to set

the setup menu for this unit according to the RS-485 settings

of the camera and DVRs.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 83 84

Comentários a estes Manuais

Sem comentários

LG LE4016D-NH Manual do Utilizador Página 16

Comentários a estes Manuais