LG C Series Manual do Utilizador descarregar pdf (Página 36)

Chapter 5. Programming keypad

How to monitor fault condition in Drive group

Drive group

STOP/RST

Frequency

Current

During

Accel

Over-

current

trip

-. This message appears when an Overcurrent fault occurs.

-. Press the Prog/Ent (z) key once.

-. The run frequency at the time of fault (30.0) is displayed.

-. Press the Up (S) key once.

-. The output current at the time of fault is displayed.

-. Press the Up (S) key once.

-. Operating status is displayed. A fault occurred during acceleration.

-. Press the STOP/RST key once.

-. A fault condition is cleared and “nOn” is displayed.

When more than one fault occur at the same time,

Drive group

Over

current

Over

voltage

Motor

overheating

-. Maximum three faults information is displayed

as shown left.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 126 127

Sem comentários

LG C Series Manual do Utilizador Página 36