2 PLASMA TV
Safety Warnings
Safety Instructions
Safety Instructions
Do not place the set in direct sunlight or near heat
sources such as heat registers, stove and so on.
- This may cause a fire.
Do not use the set in damp place such as a bathroom
or any place where it is likely to get wet.
- This may cause a fire or could give an electric shock.
Bend antenna cable between inside and outside
building to prevent rain from flowing in.
- This may cause water damaged inside the set and could give an
electric shock.
Earth wire should be connected.
- If the earth wire is not connected, there is possible a danger of
electric shock caused by the current leakage.
- If grounding methods are not possible, a separate circuit break-
er should be employed and installed by a qualified electrician.
- Do not connect ground to telephone wires, lightning rods or gas
pipe.
Apparatus shall not be exposed to dripping or splash-
ing and no objects filled with liquids, such as vases,
shall be placed on the apparatus.
- This may cause a fire or could give an electric shock.
Do not insert any object into the exhaust vent.
- This may cause a fire or could give an electric shock.
Do not place heavy objects on the set.
- This may cause serious injury to a child or adult.
Do not use water while cleaning the set.
- This may cause damaged the set or could give an electric
shock.
In case of smoke or strange smell from the set, switch
it off ,unplug it from the wall outlet and contact your
dealer or service centre.
- This may cause a fire or could give an electric shock.
Do not attempt to service the set yourself. Contact
your dealer or service centre.
- This may cause damaged the set or could give an electric
shock.
During storm activity, unplug the set from the wall
outlet and don’t touch the antenna cable.
- This may cause damaged the set or could give an electric
shock.
DISCONNECTING DEVICE FROM MAINS
- Mains plug is the disconnecting device. The plug must remain
readily operable.
Use a dedicated power cord. Do not modify or extend
the power cord.
Do not install, remove, or reinstall the unit by yourself
(customer).
For electrical work, contact the dealer, seller, a
qualified electrician, or an Authorized Service
Center. For installation, always contact the dealer or
an Authorized Service Center.
Do not use if the power cord or plug is damaged, or
socket is loose. Use a dedicated outlet for this
appliance.
Do not over bend the power cord and do not place
anything on the power cord. Do not install the
monitor near any sharp edge to avoid wire damage.
Comentários a estes Manuais