LG HB6422A Manual do Utilizador

Built-In Gas CooktopsInstallation and Operating InstructionsHB6422ATo avoid the risk of accidents or damage to the Gas Cooktops,it is essential to rea

Instructions for the installer4. Gas connectionUse pipe-joint compound made for use with Natural U.L.P. gas.The burner it controls is shown next to ea

be installed. The N.G. regulator must be checked and adjusted to1.0kPa after installation.U.L.P.G. Can be connected to the inlet fitting directly.The

5. Adaptation to different types of gasBefore performing any cleaning or maintenance work, detachthe appliance from the electrical socket.The hob has

5.2 Regulation for ULPGLoosen screw A and push support B all the way. Use a double headwrench to remove nozzle C and assemble the suitable one,followi

Instructions for the installer5.3 Regulation for natural gasThe hob has been adjusted for natural gas at a pressure of1.0kPa. To allow the unit to wor

6. Final operationsHaving carried out the above adjustments, reassemble theappliance following, backwards, the instructions in paragraph “5.1Removing

Instructions for the installer6.3 Arrangement of burners on hob6.4 Lubrication of gas tapsAfter a while, the gas tap may become hard to turn or lock.

7. Using the hobBefore turning on the burners, make sure that the burner rings,caps and grids have been fitted correctly.In the Wok burner, notch A mu

Instructions for the user7.2 Practical advice for using the burnersFor better burner performance and minimum gas consumption, flatbottomed, even recip

198. Cleaning and maintenanceNever use a steam jet to clean the appliance.Before any intervention, disconnect the power supply of thedevice.8.1 Cleani

Contents2Introduction ... 31. Instructions for safe and proper use ...

8.2 Cleaning of cooking hob componentsCAUTION:do not wash these components in a dishwasher. Innormal use of the hob, the stainless steel burner caps a

FOR WARRANTY SERVICE PLEASE CONTACTLG Service on 1300 LG CARE (1300 54 2273) AUSTRALIA or0800 LG CARE (0800 54 2273) NEW ZEALANDLG Electronics Austral

3Introduction1. Instructions for safe and proper useThis manual is an integral part of the appliance and therefore mustbe kept in its entirety and in

IntroductionThe identification plate, with technical data, serial number andmarking is clearly visible under the casing.The plate on the casing must n

5Instructions for the installer2. Positioning of hobThis appliance shall be installed only by authorized persons inaccordance with AS5601 - Gas Instal

Instructions for the installerdrawing refer to the hole on the inner side of the gasket.In case of installation on a hollow compartment with doors, as

2.2 Clearance above and around domestic appliances Extract from AS5601 REQUIREMENTS 1 Overhead clearances – (Measurement A) Range hoods and exhaust

Instructions for the installerWhere B, measured from the periphery of the nearest burner to anyvertical combustible surface, is less than 200 mm, the

93. Electrical connectionMake sure that the voltage and capacity of the power line conformto the data shown on the plate located under the casing. Do