LG LSCG306ST Manual de Instalação

INSTALLATION MANUALGAS COOKTOPPlease read this guide thoroughly before installation.P/No.: MFL62725502www.lge.comHSILGNELOÑAPSE

10 INSTALLATION INSTRUCTIONS4. SEAL THE OPENINGSSeal any openings in the wall behind the cooktop and in the floor of the cabinet when hookups are comp

11 INSTALLATION INSTRUCTIONS5. ASSEMBLE THE SURFACE BURNERS CAUTIONDO NOT operate the burners without all parts in place.Place the burner caps and hea

12INSTALLATION INSTRUCTIONS7. ADJUST THE SURFACE BURNER LOW FLAME (SIMMER) SETTINGFor all surface burners except for the center burner Only For the

13INSTALLATION INSTRUCTIONSWHEN ALL HOOKUPS ARE COMPLETE Make sure all controls are left in the off position. Make sure the flow of combustion and ven

14Memo

Printed in KoreaPara comunicarse con LG Electronics24 horas al día, 7 días a la semana:1-800-243-0000 (EE.UU.)O visítenos en la Web en:us.lge.com (EE.

INSTALLATION INSTRUCTIONS2 FOR YOUR SAFETY -Do not store or use combustible materials, WARNING : If the information in this manual is not followed

INSTALLATION INSTRUCTIONS3 INSTALLATION SAFETY INSTRUCTIONS BEFORE YOU BEGIN Remove all tape and packing materials before using the cooktop. Dispose

4 INSTALLATION INSTRUCTIONS•The ventilating hood must be constructed of sheet metal not less than 0.0122” thick. Install above the cooktop with a cl

5 INSTALLATION INSTRUCTIONSDIMENSIONS AND CLEARANCES Provide enough clearances between the cooktop and adjacent combustible surfaces. These dimension

6 INSTALLATION INSTRUCTIONSINSTALLING THE COOKTOP UNIT 1. LOCATE ELECTRICAL OUTLET AND GAS SHUT-OFF VALVE BENEATH CABINET2. INSERT COOKTOP INTO

7 INSTALLATION INSTRUCTIONS1. PROVIDE ADEQUATE GAS SUPPLYThis cooktop is designed to operate at a pressure of 5” of water column on natural gas or 10”

8 INSTALLATION INSTRUCTIONSFLEXIBLE CONNECTOR HOOKUP Pressure regulatorAdapterGas Flow into RangeInstaller: Inform theconsumer of thelocation of the g

9 INSTALLATION INSTRUCTIONSELECTRICAL REQUIREMENTS 120 Volt, 60 Hertz, properly grounded dedicatedcircuit protected by a 15 A or 20 A circuitbreaker o